Storage; Troubleshooting - Philips HR2375 Mode D'emploi

Note: The front panel is heavy. Take extra caution when removing it.
4 Disassemble the front panel, the shaping disc, the shaping disc holder, the mixing
paddle, and the mixing chamber in order. (Fig. 5)
5 Use a dry cloth to clean flour residue on the main unit. (Fig. 25)
6 Clean the shaping disc with the supplied cleaning tool to remove the dough residues.
After that, you can clean it with water. (Fig. 26)
Note: For the spaghetti, thick spaghetti, angel hair and fettuccine shaping discs, let
the discs air-dry 2 to 4 hours. Then use the corresponding cleaning tool to poke out
the dough in the holes.
7 Clean all detachable parts, and wipe them dry. (Fig. 6)
8 Use a dry cloth to clean the control panel, and the exterior of the pasta
(Fig. 27)

Storage

1 Unplug the appliance and let it cool down.
Note: Make sure all parts are clean and dry before storing.
2 You can store the shaping discs in the storage drawer. (Fig. 28)

Troubleshooting

This chapter summarises the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, visit
www.philips.com/support for a list of frequently asked questions or contact the
Consumer Care Center in your country.
Problem
The indicators do not
light up.
After pressing the
On/off button the
appliance sounds but
does not work.
The safety switch is
triggered and the
appliance suddenly
stopped or suddenly
restarts during the
processing.
During processing,
the appliance stops
working when you
open the lid.
Cause
The power plug is not
connected correctly.
The mixing chamber,
the shaping disc, or
the front panel is
assembled incorrectly.
The front panel knob is
loose.
Excessive ingredients in
the pasta maker.
For safety reasons,
the appliance always
stops working when
the lid is opened during
processing.
Solution
Check whether the power plug is
plugged correctly and the outlet is
working properly.
Make sure you follow the user
manual to assemble all parts
correctly.
Make sure the front panel is securely
assembled.
The maximum amount of flour used
for each batch is 500g. If more than
500g is added, reduce the amount of
flour before next batch.
If you need to resume the previous
operation, close the lid properly, and
press the Start/pause button.
ENGLISH
9
maker.