tau K590M Notice D'installation page 21

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
7
interspersed
No.
flashes
with a pause of 1 sec.
No.
8
flashes interspersed with
a pause of 1
sec.(red):
10. SET-UP FOR OPERATION WITH TAU APPS
In order to use the TauApp and TauOpen apps, it will be necessary to connect to input M4 of the
control unit using the supplied cable, the respective T-WIFI and T-CONNECT devices. To activate the
operation of the apps see the respective instructions.
11. RESTORING AUTOMATIC OPERATION
Should the gate needs to be operated manually, use the release system. After a manual operation:
If the reset occurs after a black-out or after a manual intervention, before powering the control board
again it is necessary to place the gate in the totally open or completely closed position.
12. MALFUNCTIONS: POSSIBLE CAUSES AND SOLUTION
The automation does not start
a- Check there is 230Vac power supply with the multimeter;
b- Check that the N.C. contacts on the card really are normally closed (5 green LEDs illuminated)
and that the red opening command LEDs are turned off;
c- make sure the green DL1V led flashes every 4 seconds;
d- Set dip 6 (phototest) to OFF;
e- Check that the fuses are intact with the multimeter.
The radio control has very little range
a- Check that the ground and the aerial signal connections have not been inverted;
b- Do not make any joints on the antenna cable;
c- Do not install the aerial in a low position or behind walls or pillars;
d- Check the state of the radio control batteries.
The gate opens the wrong way
a_ Invert the position of dip-switch No. 10 after having turned off the power to the control unit.
13. GUARANTEE: GENERAL CONDITIONS
TAU guarantees this product for a period of 24 months from the date of purchase (as proved by the
sales document, receipt or invoice).
This guarantee covers the repair or replacement at TAU's expense (ex-works TAU: packing and trans-
port at the customer's expense) of parts that TAU recognises as being faulty as regards workmanship
or materials.
For visits to the customer's facilities, also during the guarantee period, a "Call-out fee" will be charged
for travelling expenses and labour costs.
The guarantee does not cover the following cases:
If the fault was caused by an installation that was not performed according to the instructions
provided by the company inside the product pack.
Make sure there are no obstacles across the path of the gate and that
it slides smoothly;
Sensitive edge safety intervention
(red)
:
A command pulse is required to carry out the closure;
Eeprom external memory fault;
Replace the external memory module;
21

Publicité

Table des Matières
loading

Table des Matières