Depaepe Telecom HD Max Photos Mode D'emploi page 16

R key (Flashing)
This key is used to transfer a call to another extension when the HD
MAX Photos is connected behind a PABX. Flashing time can be
adjusted to 100 or 300ms by programming (see « LIST OF
SETTINGS » following pages). In France, most of the PABXs will
use 300 ms flashing time. In almost all other Europeans countries,
100 ms setting should be used.
Settings programming
HD MAX Photos standard factory settings come with:
- Programming access code = 0000
- Dialling = Tone
- Hook-Flash duration = 270 ms
- Pulse mark-break ratio = 66/33
- Access to memory programming = unlocked
- Call barring = unlocked
To change settings, proceed as follows:
1) Make sure the telephone is connected to a powered C.O. or PABX
line.
2) Handset in ON Hook mode. Depress « PROG » located inside the
unit.
3) While keeping « PROG » key depressed, pick-up the handset.
4) Release « PROG » key.
5) 2 sharp « beep » tones will confirm entering the settings
programming mode.
6) Enter the 4 digits programming access code with the keypad or
with the rubber keys located inside the keypad grid (factory pre set
code is: 0000)
15