Programming Example - Dal Zotto Valli idro Manuel Utilisateur

PrOgrAMMing eXAMPLe

Let's suppose that the weekly programmer function is to be used and 4 time periods are to be used in the following way:
1st time period: from 08:00 to 12:00 every day of the week excluding Saturday and Sunday
2nd time span: from 15:00 to 22:00 only on Saturdays and Sundays, both times with a 75°c water temperature setpoint
the display will show the various programming steps.
CONTROLS PROCEDURE:
Press the key 6, set clock WILL APPEAR.
Press key 2 until "Set chrOnO" is
displayed.
ENABLE ChRONO
Press key 6, enAbLe chrOnO and Off
will appear.
Press key 4 to activate or deactivate the
chrOnO function. Select On.
Press key 6 to confirm and continue
programming.
StArt Prg1 Off will appear.
1ST TIME PERIOD SWITCh-ON
Use keys 4-5 to enter the time "8:00",
which corresponds to the switch-on
time of the 1st time period.
To confirm and continue programming,
press button 6. Press button 3 to go
back to the previous parameter.
*2ND TIME PERIOD SWITCh-ON
At this point, the second time period must be programmed.
The sequence to be followed is the same and is repeated as for the 1ST TIME PERIOD SWITCh-ON.
On this occasion it is only necessary to enter the time, for example start at 15:00 and Stop at 22:00 and to activate the days
Saturday and Sunday by setting them at "ON".
When the WeeKLy PrOgrAMMer iS Active, A bOX Of the reLAtive icOn WiLL APPeAr On the
cOntrOL bOArD.
1ST TIME PERIOD SWITCh-OFF
Set
Use buttons 4-5 to enter the time
cLOcK
"12:00", which corresponds to the
switch-off time of the 1st time period.
To confirm and continue programming,
press button 6. Press button 3 to go
Set chrOnO
back to the previous parameter.
ENABLE 1ST TIME PERIOD DAYS
Use keys 4 and 5 to enable/disable
enAbLe
the days, 2 and 3 to scroll through
chrOnO
the days; the day of the week will be
On
displayed followed by Off
select from Monday to Fridat in On,
excluding Saturday and Sunday (OFF)
SET h2O TEMPERATURE 1ST TIME
SPAN
Press key 6 to confirm and continue
StArt Prg1
programming.
Off
Use keys 4-5 to select the desired h2O
temperature.
(65-80°C)
Press key 6 to confirm and continue.
2ND TIME PERIOD SWITCh-ON
At this point, the second time period
must be programmed.
StArt Prg1
08:00
The sequence to be followed is the
same and is repeated as for the 1ST
TIME PERIOD SWITCh-ON.
| engLiSh
StOP Prg1
12:00
MOnDAy..Prg1
On-Off
Set Prg1
75°c
StArt Prg2
Off
71