Electrical Safety - Husqvarna CG 200 S Manuel D'utilisation

• PETROL VERSION. Consult
maintenance manual.
Take into account the working conditions
from health and safety point of wiew.
- Check fuel and oil level.
- To start the engine, refer to the engine
operating instructions and paragraph 7
"Starting up".
• ELECTRIC VERSION. Check the following:

ELECTRICAL SAFETY :

Operate this machine only on a supply
equipped with a 30 mA earthed current-
limiting circuit-breaker. Otherwise,
consult our catalogue for appropriate
models.
- Check the mains voltage (SINGLE PHASE, 230
V - THREE PHASE 400 V).
- Check that the motor is connected to electric
cable with conductors of 4 mm
phase) and 2.5 mm
less than 100 m. Above this length, double the
section.
- THREE PHASE : Check that the motor is
turning in the same direction as that of the
arrow located on rear cover of the motor (if not,
reverse 2 of the wires).
- To start the motor, refer to paragraph
7 "Starting up".
22
the engine
2 section (single
2 (three phase) for lengths
7 Starting up
Always take care.
Get into a comfortable, balanced
position.
Remove all adjustment tools and
wrenches from floor and machine
To start the planer, grasp the dead
man's handle (I) on the steering shaft.
The motor stops if this is released. As
a safety precaution, check regularly
that it operates correctly. Do not lock
it in position.
• PETROL VERSION:
- Refer to the manufacturers manual.
- Let the engine warm up.
• ELECTRIC VERSION:
- The planer is operated by the on/off switch
(emergency stop using the handle (I)).
• DUST EXTRACTOR:
- Fit the suction (U) hose directly onto connector
located on the back of the machine (health and
safety) [ 5].
SEE FIG.
8 Working procedure
• To mill concrete, pass the machine over several
times according to the nature of concrete and
until desired result is obtained.
• Millimetric depth adjustment [
- Action the fly-wheel (C) that will act on the
screw (D).
- Turn the nut (E) to lock the screw and secure
the cutting depth.
• Quick release:
- Pull lever (B) backwards to release the drum
quickly.
- And push forwards at the preselected depth to
resume work.
9 Belt tensioning
• Check periodically belt tension and retighten it
when necessary but do not overtighten, by
means of the nut (S) and lock nut (T) [
x7].
FIG.
Never set belts beyond original
tension
6] :
SEE FIG.
SEE