Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONNECT INLET HOSES
6.
Check for leaks
Turn on water faucets to check for leaks. A small amount of
water may enter washer. It will drain later.
7.
Secure drain hose
Laundry Tub
Standpipe
4.5"
4.5"
4.5"
4.5"
4.5"
(114 mm)
(113 mm)
(114 mm)
(113 mm)
(113 mm)
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with shipping strap removed earlier.
22
CONNECT VENT
1.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet
in dryer. If connecting to existing vent, make sure vent is
clean. Dryer vent must fit over dryer exhaust outlet and inside
exhaust hood. Check that vent is secured to exhaust hood
with a 4" (102 mm) clamp.
Wall
2.
4.5"
4.5"
4.5"
(113 mm)
(113 mm)
(114 mm)
Move washer/dryer to final location, taking care not to crush
or kink vent.
After washer/dryer is in place, remove corner posts and
cardboard from under washer/dryer.
Connect vent to exhaust outlet
Connecting from front
(for closet or recessed
area)
Move washer/dryer to final location
Connecting
from rear
Publicité
Table des Matières
