Antenna Installation - Kenwood KDC-BT950DAB Mode D'emploi

Installation/Connection

Antenna installation

1 Remove the front pillar cover of your car.
Front pillar
2 Clean the windscreen with the supplied cleaner (I).
(I)
– Wait until the glass surface is completely dry before
proceeding.
– Warm the surface of the windscreen with defroster if it is
cold (during winter).
3 Remove the separator (tag 1) of film antenna (F)
horizontally and paste the antenna on the windscreen.
Separator (tag 1)
Do not touch the pasting surface (adhesive side) of the film
antenna (F).
36
ENGLISH
4 Rub the film antenna gently onto the windscreen in the
direction of the arrow shown to allow it to stick firmly.
5 Remove the separator (tag 2) of film antenna (F)
vertically.
Separator (tag 2)
(F)
6 Set the position of the protrusion of the amplifier unit
(G) with the K mark on the film antenna (F) and paste.
Do not touch the lead terminal or the pasting surface
(adhesive side) of the amplifier unit (G).
• When installing the antenna on the right side
Earth sheet
Lead terminal of the
film antenna (F)
Lead contact of the amplifier unit
(metal part)
• When installing the antenna on the left side
Earth sheet
(G)
Set the position of
the protrusion with
K mark
(F)