Electrical Connection - WIKA TIF11 Mode D'emploi

5. Commissioning, operation
Tighten the threads by hand when carrying out the final assembly on
the plant. This will correspond to the delivery status of the premounted
components. The final tightening torque should be applied using a
spanner (half rotation).
EN

5.3 Electrical connection

The installation conditions and electrical connection values can be taken
from the corresponding transmitter's operating instructions and must be
observed.
Damage to cables, wires and connection points must be avoided.
■
Fine-stranded leads with bare ends must be finished with end splices
■
(cable preparation).
For the head-mounted transmitters installed, the data sheets must
■
also be considered.
12 WIKA operating instructions model TIF11