Husqvarna K 7000 Ring Manuel D'utilisation page 14

8. If it is necessary, push the guide rollers into position.
9. Install the support roller guard. Make sure that the
flanges on the guide roller are in the grooves in the
cutting blade.
10. Tighten the 4 screws that hold the support roller
guard.
11. Turn the cutting blade by hand. Make sure that the
support rollers are not set against the cutting blade.
12. Put the product in upright position.
14
13. Adjust the 2 adjuster screws until the support rollers
touches the cutting blade.
CAUTION: Do not adjust the support
rollers if the product is on its side. The
adjustment becomes incorrect and can
cause damages to the cutting blade.
14. Make sure that you can stop the support roller with
your thumb when the cutting blade is rotated.
15. Tighten the 2 locknuts on support roller guard.
16. Make sure that you can stop the support roller with
your thumb when the cutting blade is rotated.
1461 - 001 - 17.02.2020