Bosch TCC78K751 Mode D'emploi page 47

Calc'n'Clean
– : If you want to descale
and clean the appliance at the same
time, press start/stop (10) and run
o
the Calc'n'Clean programme (see
"Calc'n'Clean").
Water hardness
– : Press the arrow button
. Turn the knob
p
quired water hardness (1, 2, 3 or 4) (refer
also to "Checking and setting the water
hardness").
Coffee temperature
–
button . Turn the knob
p
temperature.
Auto off after
– : Press the arrow button
Turn the rotary knob
span after which the appliance should
automatically switch off following the
last drink preparation. A time between
5 minutes and 8 hours can be set. The
default time is one hour, but this can be
shortened to save energy.
Illumination
– : Press the arrow button
The lighting can be set to
Off after 5 min
setting) or
Tone
– : Press the arrow button
audible signal you hear when a button is
pressed can be switched
turning the rotary knob
Contrast
– : Press the arrow button
display contrast can be set from –20 to
+20 with the rotary knob
setting is 0.
Water filter
– : Each time a new water i lter is
inserted in the water tank (14), it must be
rinsed:
1. Place the water i lter in the water tank
Start with O
(14) and i ll the tank with water up to
the "max" mark.
2. Press the arrow button
[
and press start/stop (10).
o
3. Place a container with a capacity of 0.5
litres under the milk frother (12).
Bosch
TCC78K751_Heft1.indb 49
to select the re-
: Press the arrow
to set the coffee
p .
to enter the time
.
p
Off On
, (factory
.
. The
p
OFF ON
or by
.
. The
p
. The default
p
]
4. Press o start/stop (10). Water will now
run i rst through the i lter to rinse it and
then into the container.
Empty the container. The appliance is
ready to use once more.
Rinsing the i lter simultaneously activates
Service - change filter
the setting for the
display.
The i lter is no longer effective when the
Service - change filter
or at the latest after two months. It needs
to be replaced for reasons of hygiene and
so that there is no build-up of limescale
(this could damage the appliance).
Replacement i lters can be obtained
from retailers or customer service (see
"Accessories").
After every i lter change the i lter must i rst
be rinsed. Proceed as described at the
beginning of this section.
If no new i lter is used, turn the water i lter
Off
setting to .
You can i nd detailed informa-
tion about the water i lter in the
enclosed i lter instructions.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the i lter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
factory settings
– : You can cancel your own
settings and reset the factory settings. To
activate the factory settings, press
stop (10).
English | 49
display appears,
start/
o
TCC78K751 | 07/2011
28.06.2011 11:44:22