switel WTF718 Mode D'emploi page 67

Searching for a channel
Signals are searched for on all eight channels and all 38 CTCSS
codes in a continuous cycle. SC appears in the display. The chan-
nel search is stopped if radio communication is found. Press the
P button to enable radio communication.
Starting channel search
” and +
Resuming search for a channel
+
Scanning the CTCSS codes
The CTCSS codes can be scanned after an active channel has
been found.
Stopping channel search
P
Dual−channel monitoring
When dual−channel monitoring is activated, the walkie−talkie auto-
matically switches between two channels until a communication si-
gnal is detected. This means you can talk to two callers on separate
channels.
Starting dual−channel monitoring
7 x ”
+ or ,, ”
+ or ,, P
Ending dual−channel monitoring
7 x ”
+ or , OF , P
Operating the Walkie−Talkies
When dual−channel monitoring is active, the channel cur-
rently set and the additional channel appear alternately in
the display.
Start the channel search
Resume the search for a channel
Scan the CTCSS codes
End the channel search
Activate setting mode
Select the additional channel and
confirm it
Change the CTCSS code and
confirm it
Activate setting mode
End dual−channel monitoring
67