Arbonia WFC Instructions D'utilisation page 21

► D7: confirm with button (1) on the thermo-
stat.
The following message appears on the dis-
play:
► D8: press the LEARN button on the ra-
dio receiver (actuator) once.
–> LED (10) blinks green
If the LED (10) lights up continuously for ap-
proximately 5 seconds, the learning process
has failed. Restart the learning procedure.
► D9: press the LEARN button on the thermo-
stat once.
The currently set program is displayed on
the display e.g.:
–> LED (10) on the radio receiver is off
Radio communication was setup successful-
ly. The learning procedure remains saved
even after interrupting the power supply.
D10: install splash protection cover
►
The LED (11) displays the operating mode of
the heating element.
State Meaning
Lights red Heating phase
Lights yellow Setpoint temperature has
been reached, heating ele-
ment is switched off
Blinks red Radio communication
impaired, check thermostat
WFC
21