Rear Panels - BST XL Série Manuel D'utilisation

XL SERIE

REAR PANELS

XL-300/600/900
XL-1500/2000
1. CH1 INPUT ( RCA )
2. CH1 INPUT ( JACK )
It is parallel connection with CH1 XLR input, providing output signal Save as the input signal.
3. CH 1 INPUT ( XLR )
This XLR input is the balanced input. It connects to upper audio processors.
4. INPUT SENSITIVITY SWITCH
This selector is to select the input sensitivity 0.775V / 1.0V
5. LOW FREQUENCY ENHANCED SWITCH
When turn on this switch, you can obviously feel that the low frequency is saturated and the sound quality is even better.
6. AIR ENTRANCE
This part is the air entrante. Don't obstruct it.
7. CH1 OUTPUT
Use this output socket (SPEAKON) to connect the left speaker. Stereo mode: +1 connects to the positive port, -1 connects to the negative
port.
8. AC SOCKET
Connect on this socket the AC power cord. This fuse holder includes a standard specification fuse inside. It is used to protect amplifier from
damages. If the amplifier was connected to power supply but the LED is not illuminated, please check the fuse situation. If you found the
fuse broken, you must replace with a same specification fuse.
9. CH2 OUTPUT
Use this output socket (SPEAK0N) to connect the right speaker. +1 connects to the positive port, -1 connects to the negative port. When the
amplifier is in bridge mode, this output is not used.
© Copyright LOTRONIC 2012
BSTDJ.COM
Page 11