Makita DTD145 Manuel D'instruction page 8

Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
1
2
009205
To install the bit, insert the bit into the sleeve as far as it
will go.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as far as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
2
014068
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
9 mm
(3/8")
1. Bit
2. Sleeve
1. Groove
2. Hook
1
3. Screw
3
OPERATION
014066
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
N . m
Standard bolt
(ft . lbs)
120
(87)
100
(72)
80
(58)
60
(43)
(3/8")
40
M10
(29)
20
(5/16")
M8
(14)
0 1.0 2.0
Fastening time
009220
N . m
High tensile bolt
(ft . lbs)
120
(87)
M12
100
(72)
(3/8")
80
(58)
60
(43)
(5/16")
M8
40
(29)
20
(14)
0 1.0 2.0
Fastening time
009221
8
M14
(9/16")
M12 (1/2")
(M14)
(9/16")
(M12)
(1/2")
(M10)
(3/8")
(M8)
(5/16")
3.0
(S)
(1/2")
(M12)
(1/2")
M10
(M10)
(3/8")
(M8)
(5/16")
(S)
3.0