Makita DTD145 Manuel D'instruction page 6

NOTE:
To make sure the status of light, pull the trigger.
•
When the lamp lights up by pulling the switch
trigger, the light switch is in the ON status. When
the lamp does not come on, the light switch is in
the OFF status.
During the operation of switch trigger, the light
•
status cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the light status can be switched.
Reversing switch action
A
1
009211
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for
Hammering force grade
displayed on panel
Hard
S H
Medium
S H
Soft
S H
014072
The hammering force can be changed in three steps:
hard, medium and soft.
This allows a tightening suitable to the work.
Every time the hammering force button
number of blows changes in three steps.
1. Reversing
switch lever
B
Maximum
blows
Tightening when force
3,400 /min
and speed are desired.
Tightening when a good
2,800 /min
finishing is needed.
Tightening when excessive
tightening need to be avoided
because of potentially clogged
1,300 /min
female screw and broken or
damaged screw head.
is pressed, the
counterclockwise rotation.
When the reversing switch lever is in the neutral
position, the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
Changing the hammering force
1
S H
2
S H
3
S H
4
011217
Application
For approximately one minute after releasing the switch
trigger, the hammering force can be changed.
6
1. Changed in
three steps
2. Hard
3. Medium
S H
4. Soft
5. Hammering
force button
5
Work
Tightening in underwork
material/ Tightening long
screws/ Tightening bolts.
Tightening in the finishing
board, plaster board.
Tightening sash screw/
Tightening small screws
such as M6.