HQ Power VDPLW2300 Notice D'emploi page 5

6. Operation
• Initialization
Initialization starts as soon as you connect your VDPLW2300 to the mains. After the initialization, the LCD will
display "Addr " when there is a DMX signal,
***
the projector will preset a non DMX running mode: auto, sound or manual.
• LCD Menu
Turn the jog wheel in a clockwise direction to display the following sequence:
Addr***, Manual blue***, Manual Green***, Manual Red***, No DMX/Sound/Manual, Chase 8 s***f_**,
Chase 8 s***f_**, Chase 7 s***f_**, Chase 7 s***f_**, Chase 6 s***f_**, Chase 6 s***f_**, Chase 5 s***f_**,
Chase 5 s***f_**, Chase 4 s***f_**, Chase 4 s***f_**, Chase 3 s***f_**, Chase 3 s***f_**, Chase 2 s***f_**,
Chase 2 s***f_**, Chase 1 s***f_**, Chase 1 s***f_**, DMX mode 8-group/4-group/2-group/1-group, DMX mode
3channel/6channel.
The above sequence is looping when rolling the wheel in an anticlockwise direction. Press the jog wheel to enter the
setting.
NOTE: Whenever idle for 3 seconds, the LCD will display "Addr
present DMX address. When there is no DMX signal, the projector will preset a non DMX running mode: auto,
sound or manual. The LCD returns to the last menu option when operating the wheel again.
• Addressing
The DMX address is defined as the first channel from which the VDPLW2300 will respond to the controller. Press the
wheel and rotate to change the address. After setting the desired address, confirm by pressing the wheel again.
• Light Brightness Adjustment
The LED brightness is manually adjustable. Press the wheel and rotate to display following setting options:
Manual blue*** (adjustment of the blue LEDs)
Manual green*** (adjustment of the green LEDs)
Manual red*** (adjustment of the red LEDs)
The adjustment value ranges from 0 ~ 255 – the higher the value, the brighter the LEDs will be. To enter these
settings, press the wheel.
• Non DMX Running Modes
Disconnect the device from the DMX signal first. Press the jog wheel and scroll to No DMX Auto/Sound/Manual.
Press the wheel again to enter. Select your mode (Auto: auto running mode – Sound: sound activation – Manual:
manual mode), press to confirm.
Chase
A chase is a sequence of different steps in a continuous loop. The VDPLW2300 allows you to select up to 8
different chases with adjustable speed and fade time.
Example: To set the fade time of chase 8, press the wheel and rotate to select Chase 8 s *** f_**. Pay attention to
the position of the cursor. Scroll the wheel to switch the cursor between speed (s ***) and fade time (f **). When
VDLPW2300
indicating the present DMX address. When there is no DMX signal,
***
" when there is a DMX signal,
***
5
indicating the
***
HQPOWER