External Dispenser Controls - KitchenAid KRFC704FBSS Guide De L'utilisateur

Table des Matières

Les langues disponibles

Max Cool

The Max Cool feature assists with periods of high refrigerator

use, full grocery loads, or temporarily warm room temperatures.

To turn on the Max Cool feature, press the Max Cool button.

■

When the button is pressed, the icon will blink 3 times and

appear on the display screen.

To manually turn off the Max Cool feature, press the Max

■

Cool button and the display will blink 3 times and turn off.

The Max Cool feature will remain on for 24 hours unless

manually turned off. Adjusting the refrigerator temperature will

automatically turn off the Max Cool feature.

NOTE: Setting the freezer to a colder temperature may make

some foods, such as ice cream, harder.

Max Ice

The Max Ice feature assists with increasing the cooling for the

freezer compartment in order to increase ice production.

To turn on or off the Max Ice feature, press the Max Ice

■

button. When the button is pressed to turn the feature on, the

icon will blink 3 times and appear on the display screen.

To manually turn off the Max Ice feature, press the Max Ice

■

button and the display will blink 3 times and turn off. The Max

Ice feature will remain on for 24 hours unless manually turned

off. Adjusting the freezer temperature will automatically turn

off the Max Ice feature.

NOTE: Setting the freezer to a colder temperature may make

some foods, such as ice cream, harder.

Water Filter Reset

Displays the status of the water filter. To reset the Filter, press

MAX ICE and MAX COOL for 3 seconds. After countdown, the

Good icon will blink 3 times and remain lit.

NOTE: The water filter status lights on the internal controls will let

you know when to change your water filter.

ORDER FILTER (Yellow)—Order a replacement water filter.

■

REPLACE FILTER (Red)—Replace the water filter. While

■

you are dispensing water, "Replace Filter" icon will flash

constantly from beginning to the end of dispensing. After 14

days without replacing the Water Filter, the "Replace Filter"

icon will blink 7 times and an alert tone will sound 3 times, at

the end of dispensing. See "Water Filtration System" section.

NOTE: REPLACE FILTER will remain illuminated if a filter reset

is not done.

RESET FILTER—Touch MAX ICE and MAX COOL at the same

■

time on the temperature control display for 3 seconds to reset

water filter. The display will do a 3-second countdown and

then flash the icon and play a tone.

Energy Saver

Your refrigerator will turn off the vertical mullion heater and

dispenser heater when Energy Saver is enabled.

To turn Energy Saver on, press and hold the Energy Saver

■

button for 3 seconds. The Energy Saver icon will blink 3 times

and then remain lit as shown.

IMPORTANT: When Energy Saver is enabled and the LED is ON,

the dispenser heater and vertical mullion heater will be turned off.

Press and hold ENERGY SAVER for 3 seconds again to turn

■

the heaters back on.

Sound On/Off

The Sound button allows the customer to turn the sound on

and off.

To turn on the Sound feature, press the Sound button. When

■

the button is pressed, the Sound icon will blink 3 times and

appear on the display screen.

To manually turn off the Sound feature, press the Sound

■

button and the display will blink 3 times and turn off.

Power Outage

The Power Outage indicator lets you know if the power supply

to the refrigerator has been OFF and the freezer temperature has

risen.

The control panel display will read "Power Outage" and an alert

tone will sound 3 times. Touch any button to stop the tone and

turn off the Power Outage icon.

Once the power outage has been confirmed, "Power Outage,"

will disappear.

Showroom Mode

This mode is used only when the refrigerator is on display in

a retail store. If you unintentionally turn on Showroom mode,

the word "Showroom" will light up on the display. Enter or exit

Showroom mode by pressing and holding °F/°C and CONNECT

at the same time for 3 seconds.

Sabbath Mode

Sabbath mode is designed to have all the benefits of saving even

more energy, yet maintaining food freshness. The freezer and

refrigerator user set points remain unchanged while in this mode.

If you unintentionally turn on Sabbath mode, the word "Sabbath"

will light up on the display. Enter and exit Sabbath mode by

pressing and holding °F/°C and SOUND at the same time for

3 seconds.

NOTE: You will be unable to dispense or change temperature set

points in Sabbath mode. Your interior lighting and control panels

will all be inactive in Sabbath mode.