Other Settings; Equaliser; Factory Reset - Hama IR110 Mode D'emploi

Note
You have to enter the entire network configuration (IP
address, Subnet mask, Gateway address, DNS) in the
following screens. You can select the individual digits
by turning the navigation controller and pressing the
[ENTER] button. Refer to the configuration of your own
network for the network information required, or request
this information from your network administrator. Once
all the data required has been entered, the radio will
then try to connect to the network.
SSID > Enter SSID
Note
If you have a hidden or an undetectable WLAN network
you must enter the required network ID (SSID) by turning
and pressing [ENTER] and confirming with ‚OK'.
After entering the network ID you are prompted to select
the encryption method. Depending on your network
configuration, select one of the following options:
Open > [ENTER] button > (No key)
Or
Pre-Shared Key > [ENTER] button > (not activated/WEP)
Or
WPA > [ENTER] button> (TKIP/AES)
Or
WPA2 > [ENTER] button> (TKIP/AES)
Note
For the Pre-Shared Key, WPA and WPA2 methods you
then still have to enter the required network key into
the entry field by pressing and turning [ENTER] and
then using ‚OK' to confirm. The radio then attempts to
establish a connection.
(SSID, encryption and key depend on the configuration
of your access point)
14

5.2.3 Other Settings

In addition to the already mentioned system settings of
Internet settings (5.2.2.4), Time settings (5.2.2.1 and
5.2.2.2) and Language (5.2.1), other settings can be
adjusted on the radio. Access system settings as follows:
[MENU] > System settings

5.2.3.1 Equaliser

The radio has a selection of preset audio settings that
differ in terms of bass, treble and volume. You can switch
between different modes by turning the navigation
controller, and select your desired mode by pressing the
[ENTER] button.
In addition to the preset modes, you can also program your
own mode. To make the desired settings, select menu item
"My EQ profile setup" and confirm this menu item with the
[ENTER] button.
You can now set the bass and treble levels. To do this,
select the variable to be changed and turn the navigation
controller in the direction desired.
Press the [ENTER] button to confirm your settings.
You can also activate the volume booster. Once you have
made your settings, please press the [BACK] button on the
radio and confirm that your settings should be saved by
pressing the [ENTER] button.
Now select the entry "My EQ" from the list of modes to use
this profile.

5.2.3.2 Factory Reset

In order to revert to the delivery state in terms of the
software select the menu item ‚Factory Reset' and confirm
this selection using [ENTER]. A query then appears to
confirm, which you must then in turn confirm with ‚Yes'.
After the process completes the radio is in standby
operation and all previous configurations and settings have
been reset.
Warning
• All saved presets are wiped when reverting to factory
settings.