Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.4
NOTE
If the machine does not move forward with the lever in
!
the «
then immediately return to the «
2.5
2.5 Cutting height adjustment
The cutting height is adjusted by the levers (1). The four wheels must be adjusted
to the same height. DO THIS WHEN THE CUTTING MEANS IS STATIONARY.
2.4 Converter control lever (if fitted)
In the models with drive systems, the converter con-
trol lever (if fitted) allows the operator to regulate for-
ward gear speed. To do so, move the lever (1) following
the indications provided near the control lever.
IMPORTANT! The engine must be running and the
drive engaged when switching from one speed to
another. Do not touch the converter control when
the engine is stopped. Doing this could damage the
converter.
» position, simply move the lever to «
» and
» position.
Publicité
Table des Matières
