Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.2 Drive adjustment
4.2
On power-driven models, the drive belt tension is obtained by
adjusting the nut (1) until the indicated measurement (6 mm) is
obtained.
4.3
wiring, making sure the charge level is good.
Electric push-button ignition models
•
Follow all the instructions provided in the engine Instruction Manual.
4.4
4.3 Battery recharging (where applicable)
Electric key ignition models
•
To recharge a flat battery, connect it
to the battery charger (1) following the
instructions in the battery maintenance
manual. Do not connect the battery
charger directly to the engine terminal. It
is not possible to ignite the engine using
the battery charger as a power source,
as it may get damaged. If you do not use
the lawnmower for a long period of time,
disconnect the battery from the engine
4.4 Adjusting the converter cable (if fitted)
This adjustment is necessary when the lever
(1) tends not to remain in the «
With the lever (1) in the «
the cable adjuster (2) in the direction indi-
cated by the arrow as needed to ensure the
lever remains in position.
IMPORTANT! The adjustment must be made
when the engine is off.
114
115
» position.
» position, turn
Publicité
Table des Matières
