Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
After each use, disconnect the spark plug cable and check for damage.
5.
Keep all nuts, bolts and screws tight to be sure the machine is in safe wor-
king condition. Routine maintenance is essential for safety and for maintai-
ning a high performance level.
6.
Check that the cutting means screws are properly tightened on a regular
basis.
7.
Wear work gloves when handling, disassembling and reassembling all cut-
ting means.
8.
Keep the cutting means well balanced during sharpening. All work on the
cutting means (disassembly, sharpening, balancing, reassembly and/or
replacing) are demanding jobs that require special skills as well as special
tools. For safety reasons, these jobs are best carried out at a specialised
centre.
9.
Be careful during adjustment of the machine to prevent entrapment of the
fingers between moving parts of the cutting means and fixed parts of the
machine.
10. Do not touch the cutting means until the spark plug cable has been discon-
nected and the cutting means is completely stationary. When servicing the
cutting means, bear in mind that, even though the spark plug cable is discon-
nected, the cutting means can still move.
11. Check the side discharge guard, the rear discharge guard and the grass
catcher frequently. Replace them if they are damaged.
12. Replace any instruction or warning message stickers, if damaged.
13. Store the machine out of the reach of children.
14. Do not store the machine with fuel in the tank in an area where the fuel va-
pours could reach an open flame, a spark or a strong heat source.
15. Allow the engine to cool down before storing in any enclosure.
16. To reduce fire hazards, keep the engine, silencer, battery compartment and
petrol storage area free of grass, leaves, or excessive grease. Always empty
the grass catcher and do not leave containers full of cut grass inside storage
areas.
17. To reduce fire hazards, check there are no oil and/or fuel leaks on a regular
basis.
18. If the fuel tank has to be emptied, this should be done outdoors once the engi-
ne has cooled down.
E) TRANSPORTATION AND HANDLING
1.
Whenever the machine is to be handled, lifted, transported or tilted you must:
Publicité
Table des Matières
