Maintenance And Service; Maintenance And Cleaning - Bosch Intuvia Notice Originale

English–8
Power Supply of External Devices via
USB Connection
With the USB connection, it is possible to operate and charge
most devices whose power supply is possible via USB (e.g.,
various mobile phones).
Prerequisite for charging is that the on-board computer and a
sufficiently charged battery pack are inserted in the eBike.
Open the protective cap 8 of the USB port on the on-board
computer. Connect the USB connection of the external device
to the USB port 7 on the on-board computer using the USB
charging cable Micro A – Micro B (available from your Bosch
eBike dealer).
Once the consumer has been disconnected, the USB connec-
tion must be sealed again carefully with the protective cap 8.
 A USB connection is not a waterproof plug-in connec-
tion. When riding in the rain, an external device must
not be connected and the USB connection must be com-
pletely sealed with the protective cap 8.

Maintenance and Service

Maintenance and Cleaning

Do not immerse any components, including the drive unit, in
water or clean them with pressurised water.
Clean your on-board computer using a soft cloth dampened
only with water. Do not use any detergents.
Have your eBike system checked by an expert at least once a
year (including mechanical parts, up-to-dateness of system
software).
The bicycle manufacturer or dealer may also base the service
date on the distance travelled and/or a period of time. In this
case, the on-board computer will show you every time it is
switched on that the service date is due in the text indication
d by displaying " Service" for 4 s.
For service or repairs on the eBike, please refer to an author-
ised bicycle dealer.
After-sales Service and Application Service
In case of questions concerning the eBike system and its com-
ponents, please refer to an authorised Bosch eBike dealer.
For contact data of authorised Bosch eBike dealers, please
refer to www.bosch-ebike.com
1 270 020 XBI | (11.4.16)
Transport
 If you transport your eBike attached to the outside of
your car, e.g. on a bike rack, remove the on-board com-
puter and the eBike battery to avoid damaging them. (If
the on-board computer cannot be fitted onto a bracket, it
is not possible to remove it from the bicycle. In this case,
the on-board computer may remain on the bicycle.)
The battery packs are subject to the Dangerous Goods Legis-
lation requirements. Private users can transport undamaged
battery packs by road without further requirements.
When being transported by commercial users or third parties
(e.g. air transport or forwarding agency), special require-
ments on packaging and labelling must be observed (e.g. ADR
regulations). If necessary, an expert for hazardous materials
can be consulted when preparing the item for shipping.
In case of questions concerning transport of the battery packs,
please refer to an authorised Bosch eBike dealer. The Bosch
eBike dealers can also provide suitable transport packaging.
Disposal
The drive unit, on-board computer including operat-
ing unit, battery pack, speed sensor, accessories and
packaging should be disposed of in an environmental-
ly correct manner.
Do not dispose of eBikes and their components into house-
hold waste!
Only for EC countries:
According to the European Guideline
2012/19/EU, electrical devices/tools that are
no longer usable, and according to the European
Guideline 2006/66/EC, defective or used bat-
tery packs/batteries, must be collected sepa-
rately and disposed of in an environmentally cor-
rect manner.
The integrated battery pack in the on-board computer may
only be removed for disposal. Opening the housing shell can
destroy the on-board computer.
Please return battery packs and on-board computers that are
no longer usable to an authorised bicycle dealer.
Li-ion:
Please observe the instructions in sec-
tion "Transport", page English–8.
Subject to change without notice.
Bosch eBike Systems