Alecto DVC-1000 Mode D'emploi page 54

7.4 ADDITIONAL SETTINGS AND FUNCTIONS
Press the button in the overview screen to open the additional settings and functions. You may adjust the
following functions in the settings screen:
(the description of the icon may differ somewhat, depending on the operating system).
Camera name: To enter a camera name or to edit the camera name.
Camera password: To change the camera password when entered incorrectly.
Change password: To change the password of the camera.
WiFi Networks: To change the WIFI network on which the camera is registered.
Notification interval: To select the interval between notification messages.
Recording mode: To determine how video must be recorded in the internal memory (8G) of the camera:
Off.
Continuous recording.
During alarm notification. Only record upon ringing the doorbell and/or motion detection (the alarm
Time zone: to enter the correct time zone for the correct time. For the Netherlands during winter time
GMT+1 and during summer time GMT+2.
Format SD card: To format the internal memory of the camera.
Attention: All recordings are erased.
Alarm setting: This setting must be used to send notifications to your smartphone or tablet. This
setting contains the following functions:
- off: no notification
- on/low: notification only when the doorbell pusher is pressed.
- on/medium: notification when the doorbell pusher is pressed and low motion detection
- on/high: notification when the doorbell pusher is pressed and medium motion detection
- on/max: notification when the doorbell pusher is pressed and maximum motion detection
Camera info: Provides information about the camera and the internal memory.
Reconnect: This restores the connection in case of a connection error.
Remove this device: To remove the camera from the app.
No recording.
Always record
setting must be activated)
- 54 -