Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.0
Preparation before the installation
To have the doorbell camera work via the WIFI network and the associated APP on the phone or tablet, it
must first be registered on the WIFI network.
1.
Connect the supplied battery to the doorbell camera via the connector and then insert the battery into
the battery compartment.
2.
Connect the doorbell camera to a doorbell transformer or a separate adaptor (i.e. power source) of 12
Volts and 1 Amp. The power supply may provide either direct current or alternating current, however
please use a power supply of at least 1A. Press the clip at the top of the terminal block and insert the
wires into the terminal block. Do not yet press the doorbell of the camera; otherwise you'll cause a
short circuit in the power supply. The battery is now being charged.
12v- or
12VDC
UTP/LAN
connection
3.
Connect the supplied separate UTP connection to the terminal block at the bottom of the doorbell
camera. Now use a UTP cable to connect the doorbell camera with the router used in your home.
Advice: Charge the battery for at least 12 hours.
4.
Download the AlectoCam APP via the Play Store or App Store.
L A N
- 46 -
Publicité
Table des Matières
