Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.0
INSTALLATION
When replacing the doorbell pusher for the DVC-1000, check whether it's connected in the following way.
Also check whether the current doorbell is of the mechanical type. A mechanical doorbell has a spindle and
clapper. Doorbell transformers providing 8V must be replaced by a 12V type.
Power
Power
voeding 12V~
1.
Ensure the doorbell installation is without power by switching off the doorbell transformer.
2.
Remove the push-button that is mounted at the (front) door.
3.
Place the bell pusher holder of the DVC-1000 onto the door post. Make sure to lead the wires through
the hole of the terminal block.
4.
If required, strip the wires to ensure that the copper core of the wire is exposed by 5mm.
5.
Connect the wires to the terminal block of the bell pusher by depressing the pull tab at the top and in-
serting the wires into the connector. Release the pull tab again making sure that the wires are secured
in the terminal block.
6.
Reconnect the doorbell transformer to the mains and switch it back on.
7.
The doorbell camera will then start-up and connect to the router.
8.
Press and hold the Reboot button at the rear for 5 seconds to have the doorbell start-up correctly.
9.
Click the doorbell pusher into the holder and use the locking screws at the bottom to fasten the door-
bell pusher into the holder.
10. The doorbell camera is now ready for use.
Note: If the battery capacity is too low and the battery is not sufficiently charged, the WIFI connection will
fail. You'll be informed of this through a voice prompt. As soon as the battery is sufficiently charged, the
connection with the WIFI router will be made and then you'll have access to the doorbell via the app.
Conventional doorbell installation
Conventionele bel installatie
DOORBELL
BEL
- 49 -
Push-button
Publicité
Table des Matières
