Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Android
Go to the Play Store
and search for AlectoCam
or
iOS
Go to the App Store
and search for AlectoCam
Install the following APP:
3.0
TO REGISTER THE CAMERA ON YOUR SMARTPHONE OR TABLET
1. Connect the doorbell camera according to the instructions in the paragraph "2.0 Preparation before
the installation".
2. Launch the AlectoCam App (attention: use the same network as the camera when it's connected using
a LAN cable).
3. Press the + sign in the upper right corner in the display to add a camera.
4. You may activate the camera in two ways:
A: Press 'Scan' to scan the UID code marked on the doorbell camera using a QR code scanner. If the scan
fails, you may enter the UID code manually.
Go to step 5.
B: Press 'Search' to search for available cameras on the same network as the network on which your
smartphone/tablet is registered. This only works when the smartphone or tablet uses the same WIFI router
or modem connection to which the doorbell camera is connected. The following screen shows the found
camera(s).
Select the camera. Go to step 5.
5. Enter the correct password of the doorbell camera in the password field. The default password is
"admin".
6. You may change the name of the doorbell camera into a personal name (e.g. front door) in the field
"Device name".
7. Now press the check mark √ in the upper right corner.
8. If the correct password is entered, the APP will make contact with the camera. If this is not the case, the
pop-up dialogue "Wrong password" will appear. Please enter the correct password.
9. The APP will now login on the doorbell camera. The message "Camera successfully added" will appear
followed by the overview screen. Press the camera screen (which may still be gray) to see a live image.
A: QR code
B: Search via LAN.
- 47 -
Publicité
Table des Matières
