Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ATTENTION:
The rechargeable battery may still need to be charged. As soon as the doorbell trans-
former is switched on, the battery starts charging. For a correct functioning the battery must be reasonably
charged. This may take up to 24 hours.
Because the battery is being charged, a low voltage runs through the circuit that also runs up to the door-
bell. This may cause the clapper to vibrate somewhat. You can resolve this by placing the supplied resistor
over the spindle. If this is not sufficient, you may place a second resistor over the spindle.
- 50 -
Resistor
Weerstand
DOORBELL
BEL
Publicité
Table des Matières
