Simplified Eu Declaration Of Conformity - Urmet 1051 Série Guide Rapide

Use microwave Test mode to determine the microwave range and adjust the range using the microwave range trimmer, if needed. Make
sure that microwave test mode is off after having completed the test, setting Jumper JP3 to OFF and returning the detector to normal
operation.
Learning procedure
1. Orient and insert the battery according to the polarity.
2. The red LED will start blinking for 30 seconds to indicate that the detector is being initialised. During initialisation, the detector
will not be activated. It is advisable to move away from the detection area during this time. At the end of the initialisation time,
the red light goes off and the detector passes to normal operation.
3. Set the control unit to learning mode; see the instruction manual of the control unit for details.
4. Press the Learn/Test button to transmit the signal to the control unit
5. The corresponding information of the device is displayed if the control unit receives the signal. Refer to the manual of the
control unit to complete the learning process.
6. Put the control unit in Walk Test mode (motion Test) after the detector learning procedure. Hold the detector in the required
position, press the Test button to check that the concerned position is within the communication coverage range.
7. Proceed with the installation after having ascertained that chosen position is satisfactory.
Installation
The detector was designed to be mounted on a flat surface or in a corner using the fixing screws and the anchor bolts provided.
The rear base is provided with a hole arrangement when the plastic is thinner to allow mounting. There are two hole arrangements on
the back for fixing on surface, while there are four on the sides of fixing to a corner.
Surface mounting

I. Separate the base and the cover.
II. Perforate the appropriate hole arrangements on the inner
side of the base.
III. Using a template for the holes, make the holes in the
surface.
IV. Insert the anchor bolts if the device is fixed to plaster or
bricks.
V. Screw the base into the anchor bolts.
VI. Arrange the base on the cover.
Corner mounting:

I. Perforate the fixing hole arrangements on the triangular
bracket provided.
II. Using a template for the holes, make the holes in the
corner.
III. Insert the anchor bolts and screw the bracket onto the
anchor bolts with the two position indicators on the top
towards the user.
IV. Install the detector on the hooks of the triangular bracket.
The tamper switch is pressed against the bracket in this
manner. The four angular arrangements are not necessary unless the triangular bracket is used for
corner mounting.
< N O T E >
< N O T E >

Be careful to perforate in the thin, pre-cut areas.
Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR DUAL TECHNOLOGY DETECTOR 1051/103 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.urmet.com.
LINK TO ACCESS THE PRODUCT TECHNICAL SHEET AND DOWNLOAD THE COMPLETE MANUAL
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the
time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health
and the environment. For more information about where you can drop off your waste equipment for recycling, please contact your local
city office, your household waste disposal service or the shop where you purchased the product.
DS1051-037

SIMPLIFIED EU DECLARATION OF CONFORMITY

Arrangements for
central holes for
mounting on flat
surface
Recess for
tamper
compression
Arrangements
for mounting the
corner bracket
Hole arrangements
for fixing bracket
Triangular bracket for
corner installation
5