Operating Instructions; Overview; Prior To Starting Up; Mounting The Disc Sanding Pad - APA 20991 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

1 Power cable
2 Speed setting
3 ON/OFF switch
4 Threaded bushes for handle
5 Protective cover
6 Mounts for disc sanding pads
Figure 1: Overview 1

6.2 PRIOR TO STARTING UP

6.2.1 MOUNTING THE DISC SANDING PAD

Make sure that the mains plug is removed from the socket. Place the spanner (position 11 in the overview) on the
hexagonal bar of the mount for disc sanding pad (position 6 in the overview), image 4. Screw the threaded bolts of
the disc sanding pad (position 7 in the overview) in clockwise direction on the polishing disc mount, image 5. Resist
using the spanner and tighten the disc sanding pad.
Figure 4: Place a wrench

6.2.2 MOUNTING THE D-HANDLE

Make sure that the mains plug is removed from the socket.
Unscrew both the Allen screws at the side of the protective cap (position 5 in
the overview) using the Allen key (position 12 in the overview), image 6, and
pull the protective cap to the front.
Press the D-handle (position 9 in the overview) on the mounts of the
protective cap, image 7. Using knob grids, you can adjust the inclination of
the handle.
7 Disc sanding pads
8 Polishing sponge
Figure 2: Overview 2
Figure 5: Screw the disc sanding pad on
9 D-handle
10 Additional handle
11 Spanner
12 Allen key
13 Carbon brushes
Figure 3: Overview 3
Figure 6: Remove the protective cap
Figure 7: Insert the D-handle
9