Applying Polishing Agent On The Paint; Polishing The Paintwork; Maintenance And Care; Notes Regarding Environmental Protection - APA 20991 Manuel De L'opérateur

6.3.2 APPLYING POLISHING AGENT ON THE PAINT

Apply the product only to painted surfaces, never to plastic parts or rubber seals. Using the polishing sponge, dab the
care product onto various spots on the surface to be polished. Adjust the speed to the lowest level using an adjustment
wheel (position 2 in the overview). Hold the device using both the hands. Rest the device with polishing sponge on
the surface to be processed. Switch the device on using the ON/OFF switch (Position 3 in the overview). Pass the device
evenly over the paintwork. Do not put pressure on the device. The work is carried out by the rotation process, not the
pressure on the paintwork.
First treat the large, fl at surfaces such as bonnet, root and boot lid. Then move on to smaller areas, such as doors and
wings. For areas that cannot be reached using the polishing machine, remove the polishing sponge and polish by hand.

6.3.3 POLISHING THE PAINTWORK

After you have evenly applied and worked in the care product, it must be removed and the paintwork must be polished.
Depending on manufacturer/type, the applied polishing agent must be completely dry. Now completely remove the
care product by polishing the paintwork in the same order in which you applied the polish. Set a suitable speed for your
care product.
Reset the speed to the lowest level after every disconnection. Avoid accidents during the next restart.

7. MAINTENANCE AND CARE

Clean the polishing machine after each use. Pay particular attention to ensure the ventilations slots are clean To do this,
use a dry, soft cloth. Do not use aggressive cleaning agents or solvents. Never allow liquids to get into the device. You
can use compressed air at a low-pressure to blow-out the device.
The polishing sponge must be washed by hand in warm water. Leave the polishing sponge to air dry.
Store the polishing machine without the polishing sponge. Position the polishing machine in such a way that the
polishing plate is not distorted. Do not place other objects on the polishing plate.
The carbon brushes may be replaced only after the expiry of warranty of an specialist electrical dealer.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste! Electrical and electronic scrap must be
collected separately and disposed of in an environmentally responsible manner for recycling. Please contact
your community or city administration regarding disposal options for electrical and electronic scrap.

9. REPLACEMENT PARTS AND ACCESSORIES

Item number 20995 Polishing sponge, solid, 30 mm, Ø 150 mm (replacement for the polishing sponge supplied)
Item number 20996 Polishing sponge, soft, 30 mm, Ø 150 mm

10. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
11