PRO-PULSE 6113.468 Manuel De L'utilisateur page 46

Bdal 6113.468 07.12.2009
OPERATION
1. Tabletop
2. Right fence
3. Cutting depth
4. Workpiece
5. Successive cut
6. Cutting depth
7. Router bit
Using the router as a jointer
See Figure 16
NOTE: Make sure boards that are to be jointed together are true and
smooth. Also make sure edges are prepared properly.
1. Loosen the knobs holding the fences in place.
2. Against the left fence, place a straight edge.
3. Slide fence until straight edge touches the outside diameter
of the router bit.
4. Tighten the left fence knobs.
5. Position the right fence to the desired depth of the cut.
6. Tighten the right fence knobs.
7. Securely tighten the router bit, and make sure the router is properly
attached to the router table as previously detailed in this manual.
8. Swing the safety shield over the router bit.
9. Your router/router table is ready to use.
NOTE: Try a piece of scrap wood to check for correct adjustment.
When standing in front of router table, feed work from right to left.
1. Left fence
2. Knobs
3. Right fence
4. Depth of cut
5. Router bit
6. Straight edge
46
12:24 Uhr Seite 46
2 1
6 5
Fig. 15
3 2
4
Fig. 16