PRO-PULSE 6113.468 Manuel De L'utilisateur page 38

Bdal 6113.468 07.12.2009
MOUNTING THE ROUTER
See Figure 7
6. Mount the router with adapter base plate using the through holes in the
tabletop. Assemble with 3 screws (R) through tabletop and into the
adapter base plate at position H. (The adapter base plate comes from
the factory with the nuts pressed into it.) Tighten securely.
Make sure the screws from router base plate are long
enough to mount router securely. Replace with longer
screws if necessary. NOTE: When mounting router using
F hole pattern pan head screws must be used. All other
hole patterns use countersink screws. Make sure screws
are assembled flush or below surface of the adaptor
plate.
Always support router when mounting and dismounting
from the router table.
38
12:24 Uhr Seite 38
R
R (3)
Fig. 7