PRO-PULSE 6113.468 Manuel De L'utilisateur page 39

Bdal 6113.468 07.12.2009 12:24 Uhr Seite 39
MOUNTING THE ROUTER
II. Mounting Routers with Three-Hole Base Plate (Hole Pattern "E")
See Figure 8
1. Remove router base plate from router by removing screws.
2. Loosen knobs and slide fences so that notches in fence line up to clear
mounting holes.
3. While holding router upside down, position it to the underside within the
center ring of the tabletop.
4. Rotate router until the three mounting holes in router base line up with
the three larger holes in the tabletop.
5. Insert three machine screws from router base plate through holes in
tabletop and into holes in router base. Tighten securely.
6. To mount Craftsman routers that use the E-hole pattern to the tabletop,
use three button head flange screws 10 - 32 x 9/16" (X) provided.
NOTE: For ease of use, position the router so the ON-OFF switch is
accessible from the front of the table.
X (3)
Make sure the screws from router base plate are long
enough to mount router securely and the head of the
screw does not protrude above the tabletop. Replace
if necessary.
NOTE: Screws from
router base plate
or button head
flange screws (X).
Fig. 8
39