Safety Instructions - PRO-PULSE 6113.468 Manuel De L'utilisateur

Bdal 6113.468 07.12.2009 12:24 Uhr Seite 28

SAFETY INSTRUCTIONS

AVOID ACCIDENTAL STARTING. Make sure all switches are in "OFF"
position before plugging in the tool.
NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or
if the cutting tool is accidentally contacted. DO NOT store materials above
or near the tool making it necessary to stand on the tool to reach them.
HANDLE POWER CORD CAREFULLY. NEVER carry tool by cord or yank
it to disconnect from receptacle. Protect cord from heat, oil and sharp
edges. For outdoor operation, use extension cords intended for outdoor use.
AVOID A DANGEROUS ENVIRONMENT. DO NOT use power tools in
damp or wet locations or expose them to rain. Keep work area well lit and
provide an adequate amount of work space around the tool.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to ensure that it will oper-
ate properly and perform its intended function. Check for alignment of mov-
ing parts, binding of moving parts, breakage of parts, mounting and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
CHECK DIRECTION OF FEED. Feed work into a blade or cutter against
the direction of rotation of the blade or cutter only.
NEVER LEAVE TOOL RUNNING UNATTENDED. Turn power off. Do not
leave tool until it comes to a complete stop.
SECURE ROUTER TABLE. DO NOT attempt to use your router table
unless it is fastened firmly to your workbench or floor.
DISCONNECT TOOLS BEFORE SERVICING. When changing bits, make
sure router is unplugged.
KEEP GUARDS IN PLACE. Be sure guards are in working order, properly
adjusted, and aligned.
KEEP HANDS AWAY FROM CUTTING AREA.
STORE PROPERLY. Do not store router table outdoors or in a damp
location. Always remove router from table after use.
KEEP WORK AREA CLEAN. ALWAYS keep your work area clean,
uncluttered, and well lit. DO NOT work on or place router table legs on
floor surfaces that are slippery from sawdust, oil, water, or wax.
DO NOT FORCE THE TOOL. Do not force tool or attachment to do a job
for which it was not designed. It will do the job better and more safely at
the rate for which it was designed.
USE CLAMPS OR A VISE TO HOLD WORK WHEN PRACTICAL.
Using clamps or a vise to hold work is safer than using your hand. It also
frees both hands to operate the tool.
28