Controls And Indicators - Welbach PROLOX 60A Manuel D'utilisation

4 setting options are available
Option No. 1:
off, off,
Option No. 2:
on, off,
Option No. 3:
off, on,
Option No. 4:
off, on,
1. Digital Amps Meter: Shows actual cutting current, which will vary during
operation.
2. Working Indicator Light: It will be on during cutting operation.
3. Thermal overload indicator lamp: This light turns on, and the device will
shut down if the device becomes overheated. Stop using the cutter while leaving
the power switch on to let the cooling fan operate, and the lamp will turn off
automatically when the machine has cooled down. Please pay attention to the
Rated Duty Cycle.
4. Mode Selector: Turns the air supply ON prior to cutting.
5. Power supply controller (increase button): It can adjust (increase)
thrust cutting current.
6. Power supply controller (decrease button): It can adjust (decrease)
thrust cutting current.
7. Ground connector: connect to workpiece.
8. Pilot: Connect the NON-connect control cable of the cutting torch.
9. Connect the control cable of the cutting torch
10. Torch cable connector
EN
2T-function - short time cutting
of solid material
4T-function - continuous cutting
of solid material
2T-function - short time grid
cutting
4T-function -continuous grid
cutting
46

CONTROLS AND INDICATORS

TREXUS 50
GROUND
CONNECTION
1. Power switch: Up is ON, down is OFF.
2. Digital Amps Meter: Shows actual cutting current, which will vary during
operation.
3. Thermal overload indicator lam:This light turns on, and the device will
shut down if the device becomes overheated. Stop trying to use the cutter while
leaving the power switch onto allow the cooling fan to operate, and the lamp
will turn off automatically when the machine cools down. Please pay attention to
the Rated Duty Cycle.
4. Power supply controller
EN
TORCH
CONNECTION
47