Welbach PROLOX 60A Manuel D'utilisation page 23

1. A quick fastener is located in the rear section of the machine. Connect the
air-water separator (see picture/figure)
2. Connect the compressed air supply to the air-water separator with the
help of the quick fastener. Adjust the air pressure to 4-6atm at 6 m3/h.
3. If the device becomes over pressurized, there is a pressure relief valve on
the top of the unit.
CONTROLS AND INDICATORS
PROLOX 60
5
3
4
2
1
torch connection
EN
7
6
8
9
10
air pressure-
control-knob (A)
barometer (bar)
ground connection
44
barometer (bar)
air pressure-
control-knob (A)
1. Power switch: Up is ON, down is OFF.
2. On-off switch for pilot arc function: Flipped up– turned on; flipped
down-turned off.
3. "2T" – Short time cutting. Cutting process begins with pressing the button
on the torch and stops with releasing the torch button.
4. "4T" — means producing the output current of the arc burning after first
pressing the button on the torch. The default value of the current is being set
after releasing the button on the torch. After cutting, button on the torch shall
be pressed again, this will cause decreasing the value of the current cut, until the
final current of the arc burning is reached and maintained. The device will stop
giving the output current after releasing the button on the torch.
EN
45