emerio TO-108275.1 Mode D'emploi page 6

TO-108275.1
FUNCTIONAL CHARACTERISTICS
1. Extra-wide toast aperture
2. Cancel switch
3. Electric browning control
4. Crumb tray
5. Toasting lever
6. Bun warmer
BEFORE USE
1. Place the toaster on a flat and heat resistant surface. Make sure that there is enough ventilation around
the toaster.
2. Before using the toaster for the first time, clean your toaster (see Chapter "CLEANING AND
MAINTENANCE"). Operate the toaster at least twice without bread and on the highest setting. Ventilate
the room during this period.
3. This appliance may emit a characteristic smell when you switch it on for the first time. This is normal,
and no harm.
4. Make sure the crumb tray is placed tightly on the bottom of the toaster.
INSTRUCTIONS FOR USE
1. Insert the power plug into the socket.
2. Insert up to two slices of bread in the browning slot.
3. Use the browning control switch to select the desired degree of browning between 1 and 6 (1 = lightest;
6 = darkest degree of browning). No. 3 is recommended for the first use. The degree of browning chosen
depends on the type of bread and individual taste.
4. Press the toasting lever down until it engages. The toasting process starts automatically.
5. Please remember that the toasting lever will not engage if the power plug is not inserted in the socket
and the toaster is not switched on.
6. The toaster switches itself off automatically and the toasted bread is ejected when the desired degree
of browning has been reached. The "CANCEL" switch can always be used to cancel the browning process.
Note:
(1) Take care when removing bread as the bread and the top of the toaster will still be hot.
(2) Do not change the browning selection during the toasting process. First press the "CANCEL" switch; then
turn the browning control switch to adjust the browning degree.
(3) Do not place any rolls etc. directly on the toast aperture but place them on the bun warmer.
(4) Make sure if toasting on the bun warmer, do not insert bread into the toast aperture. A fire may occur.
CLEANING AND MAINTENANCE
1. Before cleaning, make sure that you have removed the power plug from the socket. Let the toaster cool
down first.
2. Pull the crumb tray out to clean it up, reset it before using the appliance again.
3. Clean the outside of the toaster with a slightly damp cloth and wipe it dry with a soft cloth. Never dip
the toaster in water to clean it!
4. To clean the inside, turn it upside down and shake it over the sink until any crumbs adhering to the inside
fall out. Clean the crumb tray regularly to avoid crumbs accumulating inside.
- 5 -
EN