Daily Maintenance; Changing The Gasket; Descaling - Caffitaly System Professional Ama Capsule S06HS Mode D'emploi

Masquer les pouces Voir aussi pour Professional Ama Capsule S06HS:

Mode d'emploi (72 pages)

Table des Matières

Les langues disponibles

•

Take out the used capsule drawer; empty and rinse it (Fig. 6).

•

Remove the drip tray and the grid (Fig. 7). Empty the drip tray. Wash the parts with fresh

water.

•

Remove the water tank (Fig. 5); empty and rinse it.

•

Gently turn the coffee dispensing spout clockwise by approximately 45° (Fig. 15) until it

comes to a stop, then remove it. Remove the top cover of the coffee dispensing spout

(Fig. 16) and wash the components in hot water.

•

Remove the outside of the steam dispensing tube and wash it in hot water to remove any

milk residue (Fig. 17). Clean the inside using a damp cloth.

Use a soft cloth and a neutral

detergent to clean the surfaces of the

appliance. Do not use jets of water to

clean the appliance.

WARNING! If the gasket shows signs of wear (small cuts or cracks,

warping, ...) you can replace it easily using the spare gasket supplied in the

pack. Perform the following operations only when the machine is cold;

contact with the inside surfaces of the machine could cause burns.

•

Raise the lever (Fig. 1).

•

Find the gasket.

•

Remove the worn gasket (Fig. 18), extracting it if necessary with the aid of a screwdriver.

•

Insert the new gasket, ensuring that it fits snugly in place.

•

Close the lever (Fig. 3).

Descaling signal: when warning light D blinks YELLOW and the machine beeps 3 times, a

descaling cycle should be carried out, as illustrated below.

The machine features an advanced program that monitors how much water is used to

dispense beverages. This measurement provides the user with indications as to when the

machine needs to be descaled.

It is advisable to use the Caffitaly System descaling agent, designed to

comply with the technical characteristics of the machine, in full observance

of consumer safety. The descaling agent must be disposed of in compliance

with manufacturer instructions and/or with current regulations in force in the

country where the appliance is used.

CAREFULLY

Avoid contact with eyes, skin and machine surfaces.

Switch the machine off during descaling, and do not lift the lever.

A person must be present during the operation.

Do not use vinegar: it could damage your machine!

English