Function Buttons - Honeywell TC30PM Mode D'emploi

USE & OPERATION (CONTINUED)

FUNCTION BUTTONS

SPEED
Connect to the power supply and turn the SPEED knob. The fan will start. Change the speed from
Low to High (| for Low, || for Medium and ||| for High fan speed). To switch off the unit, turn the
SPEED knob to O.
COOL / SWING
You must add water before operating the unit on Cool mode. Turn the COOL
position to activate evaporative cooling. The water pump will operate and you
will feel the cooler air after the Honeycomb Cooling Media is completely wet.
Turn the COOL / SWING position to activate evaporative cooling and
the movement of the louvers. The louvers will begin to move left to right
automatically. Vertical Air Flow - You can manually adjust the lever
located at the front of the unit to change vertical air flow.
Louver
Turn the SWING position to activate the movement of the louvers.
Movement
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please
refer to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
EN 3