Transport; Functional Description; Putting Into Operation - Abicor Binzel 20G Mode D'emploi

AUT-WIG

4.1 Transport

Checking procedure
on receipt of goods
In case of damage
In case of complaints
Packaging for
returning the goods
Tab. 6
Transport
4.2 Storage

5 Functional Description

6 Putting into operation

The components are carefully checked and packaged, however damage may
occur during shipping.
Make sure that the shipment is complete by referring to the delivery note!
Check the package and components for damage (visual inspection)!
If the goods have been damaged during transport, contact the last carrier
immediately. Keep the packaging (for possible checks by the carrier).
Use the original packaging and the original packaging material. If you have
questions concerning the packaging and safety during shipment, please
consult your supplier.
Physical storage conditions in a closed room:
 Tab. 1 Physical conditions on page EN-4
The TIG welding torch is part of a welding system. When supplied with
appropriate operating resources, they produce an arc for welding. In TIG
welding, a tungsten electrode and an inert gas are used. The molten pool and
the arc are protected by the inert gas from atmospheric interferences. The collet
body or gas diffuser is used to transmit current to the tungsten electrode. The
ignition of the arc depends on the type of power supply and will therefore not
be described any further. The cable assembly serves as supply line and
includes all connection elements.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Disconnect the gas supply.
• Pull the mains plug.
5 Functional Description
EN - 7