Care & Maintenance; Cleaning; Storing; Resetting The Motor Thermostat - Ninja BN800C Série Guide De L'utilisateur

USING THE PRECISION PROCESSOR™ BOWL - CONT�
6a If using an Auto-iQ® program, first select
the program that best suits your recipe.
The preset feature will automatically
stop the unit at the end of the program.
To stop the unit at any time, press the
currently active program again.
6b If using a manual program, select your
desired speed. Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop.
7
To remove the bowl from the motor
base, turn the bowl counterclockwise
and then lift up.
16 ninjakitchen.com
8 Remove the lid by pressing the
RELEASE button on the front tab and
then lifting up on the handle. Always
remove the Chopping Blade Assembly
before emptying the ingredients from
the bowl. To remove the Chopping Blade
Assembly, carefully grasp it by the top
of the shaft and lift it out of the bowl.
9
Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.
CARE & MAINTENANCE

CLEANING

Separate all parts. Wash all containers in
warm, soapy water with a soft cloth.
• Hand-Washing
Wash blade assemblies in warm, soapy
water using a dishwashing utensil with
a handle to avoid direct contact with
the blades. Exercise care when handling
blade assemblies as the blades are sharp.
Thoroughly rinse and air-dry all parts.
• Dishwasher
All attachments are dishwasher safe. It is
recommended that the lids, containers,
and blade assemblies be placed on the
top rack of the dishwasher ONLY. Ensure
the blade assemblies are removed from
their containers before placing in the
dishwasher. Exercise care when handling
blade assemblies.
• Motor Base
Turn off the unit and unplug the motor
base before cleaning. Wipe motor base
with a clean, damp cloth.
DO NOT use abrasive cloths, pads, or
brushes to clean the base.

STORING

Wrap the power cord around the cord
wrap on the back of the motor base.
Store the unit upright and store all blade
assemblies inside or attached to their
respective containers with their lids locked
in place.
DO NOT store blended or unblended
ingredients in the Single-Serve Cup with
the Pro Extractor Blades™ assembly
attached.
DO NOT stack items on top of the
containers. Store any remaining
attachments alongside the unit or in a
cabinet where they will not be damaged
or create a hazard.
RESETTING THE MOTOR
This unit features a unique safety system
that prevents damage to the motor and
drive system should you inadvertently
overload the it. If the unit is overloaded,
the motor will be temporarily disabled.
Should this occur, follow the reset
procedure below.
1 Unplug the unit from the electrical outlet.
2 Allow the unit to cool for approximately
15 minutes.
3 Remove the container's lid and blade
assembly. Empty the container and
ensure no ingredients are jamming the
blade assembly.
IMPORTANT: Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.
If your unit needs servicing, please call
Customer Service at 1-877-646-5288.
So we may better assist you, please
register your product online at
registeryourninja.com and have the
product on hand when you call.

ORDERING REPLACEMENT PARTS

To order additional parts and attachments,
visit ninjaaccessories.com.
ninjakitchen.com ninjakitchen.com 17 17