Using The Single-Serve Cup - Ninja BN800C Série Guide De L'utilisateur

USING THE TOTAL CRUSHING® PITCHER - CONT�
5 Place the lid on the pitcher, aligning
the triangle symbol on the lid with the
triangle symbol on the handle. Press
down on the handle until it clicks into
place. The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate. Once the lid is locked in place,
press the Power button to turn unit
on. The available program buttons will
illuminate and the unit will be ready
for use.
6a If using an Auto-iQ® program, first select
the program that best suits your recipe.
The preset feature will automatically stop
at the end of the program. To stop the
unit at any time, press the currently active
button again.
6b If using a manual program, select your
desired speed. Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop
after 60 seconds.
7 To remove the pitcher from the motor
base, turn the pitcher counterclockwise
and then lift up.
12 ninjakitchen.com
8a To pour out thinner mixtures, ensure
the lid is locked in place, then open the
pour spout cap.
8b For thicker mixtures that cannot be
emptied through the pour spout,
remove the lid and Stacked Blade
Assembly before pouring. To remove
the lid, press the RELEASE button and
lift the handle. To remove the blade
assembly, carefully grasp it by the
top of the shaft and pull straight up.
The pitcher can then be emptied.
9 Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.

USING THE SINGLE-SERVE CUP

IMPORTANT: Review all warnings on
pages 4–6 before proceeding.
NOTE: Auto-iQ® programs have pauses
and changes in speed throughout
the cycle.
1
Plug in motor base and place on a
clean, dry, level surface such as a
countertop or table.
2
Add ingredients to the Single-Serve
Cup. DO NOT add ingredients past
the MAX LIQUID line on the cup.
3 Install the Pro Extractor Blades™
Assembly onto the top of the cup. Twist
the lid clockwise until it's sealed tightly.
4 Turn the cup upside down and install on
the motor base. Align the tabs on the cup
with the slots on the base, then rotate
cup clockwise until it clicks into place.
Once the cup is locked in place, press
the Power button to turn unit on. The
available program buttons will illuminate
and the unit will be ready for use.
5a If using an Auto-iQ® program, first select
the program that best suits your recipe.
The preset feature will automatically
stop at the end of the program. To stop
the unit at any time, press the currently
active program again.
5b If using a manual program, select your
desired speed. Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop.
ninjakitchen.com 13