Preparing The Remote Control; Using The Remote Control - Yamaha Soavo-900SW Mode D'emploi

Preparing the remote control

■Installing the batteries in the remote
control
2
1
Press the mark on the battery cover and
open the cover.
2
Insert the two supplied type AA, R6, UM-3
batteries following the indications (+/–)
inside the battery compartment.
3
Close the battery cover.
Replacing the batteries
Change all of the batteries if you notice conditions such as
the operation range of the remote control decreases.
Notes
• Do not use an old battery together with a new one.
• Do not use different types of batteries (for example,
alkaline and manganese) together. Each type of battery
has its own characteristics even if they are similar in
shape.
• If the batteries run out, immediately remove them from
the remote control to prevent an explosion or acid leak.
• Dispose of the batteries according to the regional
regulations.
• If a battery starts leaking, dispose of it immediately. Be
careful not to let leaking battery acid come into contact
with your skin or clothing. Before inserting new
batteries, wipe the compartment clean.
3
1

■Using the remote control

Remote control
sensor
The remote control transmits a directional infrared ray. Be
sure to aim the remote control directly at the remote control
sensor on the main unit during operation.
Handling the remote control
Be careful not to spill liquid on the remote control.
Be careful not to drop the remote control.
Do not leave the remote control in the following places:
– hot or humid places, such as near a heater or in a
bathroom
– extremely cold places
– dusty places
GETTING STARTED
Approximately
6 m (20 ft)
5
En