Philips VisaPure Advanced SC53 Série Mode D'emploi page 11

5.1.3 Cleansing procedure
1
2
3
4
5
6
7
8
9
10
22_100_2532_2_DFU-Redesign_A6_v1.indd 11
Push the brush head onto the connection pin until it locks into
position with a click (Fig. 6).
Moisten the brush head with water.Do not use the appliance
with a dry brush head, as this can irritate the skin.
Moisten your face with water and apply a cleanser to your face.
Place the brush head on your right cheek.
Press the on/off button once to switch on the appliance. The
appliance starts to operate at intensity setting 1. If you want to
use intensity setting 2, press the on/off button twice. Press three
times to switch off the appliance or wait until it switches off
automatically (Fig. 7).
Gently move the brush head across your skin from the nose
towards the ear. (Fig. 8)
Do not push the brush head too hard onto the skin to make
sure the treatment remains comfortable.
After 20 seconds, the appliance pauses briefly to let you know
that you have to move the appliance to the left cheek (Fig. 9).
After 20 seconds, the appliance pauses briefly to let you know
that you have to move the appliance to the forehead. Gently
move the brush head from left to right. (Fig. 10)
Note:
D
We advise you to not overdo the cleansing and to not cleanse
any zone longer than 20 seconds.
After the treatment, rinse and dry your face.
Your face is now ready for the next step of your daily skincare
routine.
Clean the brush head with water and mild soap.
11
18/05/15 09:08