Husqvarna Système de ramassage 52 Manuel Du Propriétaire page 7

3. Install the mount straps, bends to the inside, on the
outside of the mount tube using 5/16-18 x 2 hex
bolts and nuts.
4. Attach the front end of the mount straps to the fuel
tank brackets with 3/8-16 x 1 round head shoulder
bolts and nuts.
5. Attach the lower mount hitch to the frame with one
1/2-13 x 1 hex bolt and nut.
6. Tighten all hardware.
Semi Rear Guard
1. Find the mount tube, lower mount hitch, spacer
plate and support bracket from the kit. Attach the
mount hitch to the mount tube with 5/16-18 x 1-3/4
round head shoulder bolts and nuts. Be sure that
the elbowed arm of the tube is on the right side
with the mount hitch installed to the front.
2. Attach the support bracket to the tube assembly
with two 5/16-18 x 1-3/4 round head shoulder bolts
and nuts.
FRONT
Mount Tube
ASSEMBLY
Mount Straps
Spacer Plate
Support Bracket
Lower Mount Hitch
3. Attach the lower mount hitch to the frame. with a
1/2-13 x 1 hex bolt and nut.
4. Install the mount straps (bends are to the inside) on
the outside of the mount tube using 5/16-18 x 2 hex
bolts and nuts.
5. Attach the front end of the mount straps to the fuel
tank brackets with 3/8-16 x 1 round head shoulder
bolts and nuts.
6. To prevent contact of the left hand strap with
the EFM (Electronic Fuel Management) box on
the engine, place the foam strip on the inside of
the strap, next to the box. (Illustration location is
approximate.)
7. It may necessary to drill holes into the rear guard
to accept the hardware for the support bracket and
spacer plate. Using the bracket as a template, drill
5/16" holes.
8. Place the spacer plate between the support
bracket and the rear guard and attach both to the
rear guard with 5/16-18 x 3/4 hex bolts and nuts.
9. Tighten all hardware.
Foam Strip
Mount
Straps
Support
Bracket and
Spacer Plate
7