Location And Clearance Requirements; Mounting - onsen ON-I14L-LP Manuel D'installation Et D'utilisation

LOCATION AND CLEARANCE REQUIREMENTS

LOCATION
Choose a location for unit installation taking into account the following guidelines:
Unit must be installed indoors.
Installation is not recommended in bathrooms, bedrooms or occupied rooms that are normally kept closed.
Unit should have proper clearance as indicated below including ample clearance in front of unit for proper
service access.
Installation is recommended to be at a height that will allow easy viewing and operation of the control panel.
Heater requires a standard three prong, 120 V/60 Hz grounded AC power outlet in close proximity to the
installation location.
Heater requires a ½" gas supply line (12mm).
Ventilation requirements must be considered when choosing the installation location. Minimizing vent piping
will reduce installation costs and maximize efficiency.
CLEARANCE REQUIREMENTS
Non-Combustible
Side
2 inches
Top
2 inches
Floor
12 inches
Front
24 inches
Back

MOUNTING

WARNING
1
Identify a suitable location per section "Location and Clearance Requirements".
2
If the installation wall is not fireproof, the water heater should be cushioned with a fireproof board, of which
each rim projects beyond the corresponding rim of the water heater by 100 mm and is 10mm off the wall.
onsenproducts.com
onsenproducts.ca
ADJACENT MATERIAL COMPOSITION
50 mm
50 mm
300 mm
600 mm
zero zero
The heater MUST be installed in a vertical position with fuel gas inlet at the bottom
and exhaust vent positioned at the top. Installation in any other orientation will re-
sult in damage and will void the warranty.
800-996-5559
Combustible
6 inches 150 mm
12 inches 300 mm
12 inches 300 mm
24 inches 600 mm
1 inch (25 mm) fireproof insulating panel required
ENGLISH
support@onsenproducts.com
21