Westfalia 316259600001 Notice De Montage page 2

SIARR
04 - 146
PREPARATION
* Remove the spare wheel.
* Drop the exhaust down.
* Under the vehicle, inside the longitudinals,
locate and remove the 4 plugs (2+2) that
correspond to the points marked X.
ASSEMBLY
* Fasten the right arm "b" to the points
marked X using fastening kit X (fig.1).
* Fasten the left arm "C" to the points
marked X using fastening kit X (fig.2).
* Fasten the crosspiece "a" with the arms "b" and
"c" to the points marked Y using fastening kit Y
(if there is any play, insert the ring shims "d").
* Fasten the tow ball "e" to the points
marked Z using fastening kit Z.
FINISHING
* Tighten all of the nuts, bolts and screws
to the torques indicated below.
* Refasten the exhaust in place.
* Replace the spare wheel.
FASTENING KIT
4 off HM10x90 screws (cl.10.9)
3 off ring shims (d)
4 off spacers dia.10x20L.61 (f)
X
4 off 10/27 plain washers
4 off CS10 washers
4 off HM10 nuts (cl10)
4 off rubber washers,
thickness 10 (g)
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
Fig. 1
f
x
g
b,c
Fig. 2
2 off HM12x60 screws (cl8.8)
Y
2 off CS12 washers
2 off HM12 nuts (cl8)
6 off HM10x40 screws (cl8.8)
Z 4 off 10x27 plain washers
6 off CS10 washers
4 off HM10 nuts (cl8)
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FILE : BUREAU\NOTICEDEMONTAGE\SIARR\NDMWESTFALIA\NDM04146-A - FOLIO NDM ANG
!
Type Type
SI024 Approval No.
Tow-bar for
Logan Break e24*94/20*00*0049
(RLD)
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
316259600001
!
Affix the sticker in the position
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight cal load
1 909 kg 1 300 kg
Value
D
75 kg 7,59 kN