Mounting The Rudder Unit - Reely SKY Fournier RF-4D Notice D'emploi

f) Mounting the Rudder Unit
First remove the iron-on foil above the bore for the tail wheel (1) and the pin (2)
interlocking with the elevator unit.
Then place the tail wheel (3) onto the angled undercarriage wire and secure it
with the adjustment ring (4).
Glue the tail undercarriage wire to the rudder with liquid superglue.
Place the rudder unit (1) into the cut-out (2) to the fuselage end "dry" first.
The rudder unit must be precisely at a 90° angle to the elevator unit.
When the alignment is correct, remove the rudder unit and brush 2-component
epoxy glue onto the adhesive areas between the rudder and elevator units. After
repeated insertion and alignment, the rudder unit is fastened with a wooden bar
(3) or similar aids and two pins until the glue cures.
36
Figure 12
Figure 13