Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Do not disconnect the mains cable on the UPS system or the building wiring outlet
(earthed shockproof socket outlet) during operations since this would cancel the
protective earthing of the UPS system and of all connected loads.
6.
The UPS has its own internal power supply (battery). There is a risk that output sockets
may still be live after the UPS has been disconnected from the mains power supply.
7.
In an emergency situation, switch the UPS to the "Off" position and disconnect the unit
from the AC power supply.
8.
When the UPS is out of order, please refer to section: "trouble shooting" and call the
hot line.
9.
Equipotential earth bonding must be checked with external battery bank if any
Installation for UPS with terminal(s).
1.
An appropriate disconnect device as short-circuit backup protection should be provided
in the building wiring installation.
2.
An integral single emergency switching device which prevents further supply to the load
by the UPS in any mode of operation should be provided in the building wiring
installation according to local electrical laws.
3.
Connect the earth before connecting to the building wiring terminal.
4.
Temperature Rating - Units are considered acceptable for use in a maximum ambient of
40°C (104°F).
Connected products:
1.
Combined UPS and connected equipment leakage current should not exceed 3,5 mA.
2.
Make sure that the connected load does not exceed UPS capabilities. To ensure
improved backup time and longer battery life, we recommend a load equivalent to 1/3 of
nominal power.
3.
Do not connect appliances or devices which would overload the UPS (e.g. big motor-
type equipment)) to the UPS output sockets or terminal.
4.
Do not plug the UPS input into its own output socket.
5.
Do not plug the UPS into a power strip or surge suppressor.
6.
The UPS has been designed for personal computers. It should not be used with
electrical or electronic equipment with inductive loads such as motors or fluorescent
lights.
7.
Do not connect any household appliances such as microwaves, vacuum cleaners, hair
dryers or life-support systems to the UPS.
8.
Due to excessive consumption, laser printers should not be connected to the UPS.
9.
Please replace the fuse only with the same type and amperage in order to avoid fire
hazards.
10. For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
About batteries:
1.
It is recommended that a qualified technician change the battery.
2.
Before carrying out any kind of service or maintenance, disconnect the batteries and
verify that no current is present and no hazardous voltage exists in the terminals of high
capability capacitor such as BUS DC-capacitors.
3.
Do not dispose of the battery in a fire as it may explode.
Do not open or damage the battery! The electrolyte, fundamentally sulphuric acid,
4.
can be toxic and harmful to the skin and eyes. If you come into contact with it, wash
thoroughly with water and clean dirtied clothes.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
44
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 07 19 AA 59 203 14
Publicité
Table des Matières
