INFOSEC UPS SYSTEM E7 One 1000 RT IEC Manuel Utilisateur page 57

2.5.a Battery replacement
When the icons of
seconds, it's time to replace batteries. Contact your service representative to replace
batteries. Batteries can be replaced easily without turning the UPS off or disconnecting the
load. If you prefer to remove input power to change the batteries, press the OFF button on
the front panel for two seconds to power off the UPS and switch off utility power where the
UPS is connected.
.
CAUTION! Consider all warnings, cautions, and notes before replacing batteries.
Note: Upon battery disconnection, equipment is not protected from power outages.
Step 1

Remove front panel.
Step 4

Remove the top cover of
battery box and replace the
inside batteries.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Ligne directe – Tél + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 07 19 AA 59 203 14
and are flashing in LCD display and alarm is sounding every 2

Disconnect battery wires.

After replacing the batteries,
put the battery box back to
original location and screw it
Step 2
Step 5
tightly.
Step 3

Pull out the battery box by
removing two screws on the front
panel.
Step 6

Re-connect the battery wires.
57